Carolina and Josefine started the hack lab with a bit of research on how to connect the bluetooth to the Arduino. We then realized that we had to solder the pins to the Arduino pro micro board so that it would connect properly. We had a bit of a problem with this because we didn't know the basics of soldering. Mattias helped us to correct our mistakes (thanx!). After the mistake the connections where tested so that the pins worked properly.
At this time Julius joined us and we started to actually connect the bluetooth. This didn't work as it should. We found a lot of different examples online, that looked a lot a like, but none worked for our equipment. We also tried with an Arduino Uno but the same issues occurred as with the pro micro. We got the program to run in the end but no flow of information were detected.
By: Carolina, Josefine
Inga kommentarer:
Skicka en kommentar